Asked may 15 '13 at 1:34. The first thing you need to do is turn down the pressure, all the way to 0, and release the pressure through the prime valve and hose into a bucket.
Replace any lighting fixtures that you removed and move furniture or other items back into place.
How to clean a paint sprayer after using stain. Place the drain tube into a waste pail; After cleaning the smaller parts of the spray gun, you have to remove the siphon tube very carefully and put that in a flushing solution. Turn the prime valve to spray;
Clean your airless paint sprayer after each use. Keep running the paint gun until the clear water comes out. I clean the guns after every use;
Go slow and work one long board at a time to avoid lap marks. Remove coverings from windows, wall surfaces, bushes, shrubs and plants. Fill a bucket with clean water.
Carefully remove all tape and plastic covering from wall surfaces, windows and trim. A gallon of solvent should clean the sprayer. Place the fluid intake into flushing fluid;
Remove the fluid intake and drain tube from the paint and wipe any excess paint off the outside; Wear eye protection when using either. The sprayer also gives a more even coating.
Move everything back into place. Once you have completed spraying stain, clean up the tools and equipment. Luckily it’s pretty easy to check if your deck is ready to accept stain.
Using stain in a paint sprayer is a quicker way to complete a staining task than with a brush. The flushing solution that would be used will depend on the kind of paint that was used. Then you can sweep them off and go to town.
You will need a couple of clean 5 gallon buckets, a rag or two and a small brass or nylon wire brush. Remove all coverings from shrubs, bushes and plants. Follow paint/stain manufacturer’s recommendations and allow significant time for the stain or deck coating to dry.
Unless you are using the electric cup gun airless, i don’t favor using an airless sprayer. Check out the other parts on which the paint may have started to dry out. Remove the spray tip and tip guard from the gun;
Oil is easier on the pump than latex. Repeat with a fresh pint or two of solvent as often as necessary until the solvent stays clean. Basic procedure for cleaning an airless sprayer.
I have the following antique spray gun: With the gun pointed into the paint bucket, pull the trigger then turn the on/off switch to on In between coats i give them a quick cleaning by running either water or thinner (depending on type of finish i used) through the gun to prevent it from gumming up.
There is too much clean up involved with the airless rig, and there will be a lot of stains just sitting in the long airless hose before it reaches the tip for spraying. Then i run 2 gal of new thinner through. Store the pump with that clean thinner in it.
Leave the cap on the paint gun when you clean it. Here are guidelines for cleaning up. How to clean a paint sprayer [airless paint sprayer cleaning instructions] graco.
I would like to know what the proper or recommended way to clean the oil based stain out of my spray gun after use is. After i am finished spraying i again run either water or thinner through the gun then tear the gun apart to give it a thorough cleaning. For older decks you may need to pressure wash off old stain before getting started.
The whole idea is to keep the stain from pooling so it. Click to see full answer. Most of the stain spraying i have done has been with an hvlp sprayer.
Clean your sprayer after each use, especially if it’s a rental that you’ll have to return. When it's time to clean i run 1 gallon of recycled paint thinner or mineral spirits recapture all fluids in a 5. Plus, a clean 1 gallon bucket would be useful.
To maximize your investment on staining tools, make sure to clean them right after use. Capture all dirty fluid cap it and settle it out for the next time. I am using this stain product.
Store the sprayer with mineral spirits in the pump, hose, and gun after your painting project. For latex solid color stain, clean. If you can, peel away the excess paints from the outer surface of the spray gun.