Scrub the inside of the chimney. After you prime it once it is good to go every time.
Vacuum the inside of the grill and the firepot thoroughly.
How to clean traeger grill auger. Remove the 4 bolts holding the auger motor to the grill frame. Spot clean again if heavier cleaning is needed. On a cool grill, remove the grates, drip pan, heat baffle/shield and hopper shell to be able to see the auger parts.
I live in washington so it rains a lot here. We recommend cleaning your traeger once for every 5 times you use it. Follow this simple how to replace an auger tutorial for your traeger wood pellet grill.
Traeger should put an hour meter on the grills with a dummy light to clean ’em.turn the controller sideways and push it back into the mounting hole of the hopper.unplug your grill and empty the hopper. Insert the new auger and follow these steps in reverse to reassemble your grill. This step can be fast and easy by using a standard shop vac.
Remove the plastic connector from the auger motor. If the jam clears at this point, you are finished and can reassemble. Turn the controller sideways and push it back into the mounting hole of the hopper.
I wipe down the sides of the grill and legs as well. Dispose of old foil or drip tray liners. No reason to empty the auger if you plan on using it even semi regularly.
Pro 780, bronson 20 , char grill gasser, char griller modified offset, blackstone 3 burner griddle. This grill is a little over a year old. Remove the auger from the auger tube and clear out any debris or sawdust.
0:19 remove screws on front panel0:30 remove screws on hopper0:41 rem. Remove the drip tray and the heat baffle. Remove and clean both sides of the grill grates.
Remove the temperature controller from the hopper with a phillips head screwdriver. I haven't had any issues until recently. How to clean a traeger.
Using the traeger grill cleaner, spray all sides as heavy as needed, allow to soak for 1 minute and wipe down the grill from top to bottom. Open traeger lid and using a grill brush scrub the top of the grates. The auger jammed on my traeger and i only use traeger pellets.
If the jam is still stuck, continue to the next steps. Remove the grease bucket and change out the foil liner and clean the bucket if needed. Pull auger, motor, and bushing out of the grill.
Remove the four phillips screws securing the auger motor to the auger assembly, and remove the motor. Remove the bushing screw that secures the auger to the auger tube. Unless you purge and clean the auger tube, then you will have to prime the auger again.
The pellets i removed were not swollen from moisture. Here’s how to clean out an auger jam: Periodically remove the porcelain grill grate, grease drain pan, and heat baffle to clean the ash in and around the firepot.
Using the traeger grill cleaner, spray all sides as heavy as needed, allow to soak for 1 minute and wipe down the grill from top to bottom. Use the traeger grill cleaner and spray. How to clear an auger jam manually.
Spot clean again if heavier cleaning How do you deep clean a traeger grill? Barbecuing more equally traeger grill auger how to clean after jam utilizing charcoal to cook on the grill requires that you warm it evenly throughout the whole barbecuing area, which is a downside.
Remove the grates and set aside. If you wanted to change pellets out, just dump the hopper and fill with the new pellets. If you can't find the auger pin, call customer service.
Open pellet hopper lid, place 5 gallon bucket under the back pellet door and drain pellets into a bucket. This allows access to auger motor. Follow this simple how to clear a traeger auger jam tutorial for your traeger wood pellet grill.
If you need to do a bit of deep cleaning, which is an important part of traeger grill maintenance you can make an easy degreaser with warm water, a few drops of dawn soap and vinegar, mix this in a spray bottle and spray the grill down. Remover the lower panel underneath the hopper. Make sure all grill components are cold before vacuuming up the extra ash.
Minimizing heated spots as well as spreading out the charcoal evenly is difficult. The pellets in the auger will burn off in no time and wont change the cook or smoke much With force, try to pull the auger motor back and forth by hand to try to loosen the jam.
Make sure grill is cool and unplugged. Check the area around the grill to ensure the auger pin did not drop or fall out during assembly. Loosen the small screw that locates the auger bushing.
Unplug your grill and empty the hopper.